Noise in Telecommunication: Different Types and Methods of dealing with Noise

Akramjon  Mirzaev; Sanjar  Zoteev

doi:10.37899/journallamultiapp.v1i5.275

Akramjon Mirzaev Telecommunication Engineering Department, Tashkent University of Information Technologies, Uzbekistan
Sanjar Zoteev Telecommunication Engineering Department, Tashkent University of Information Technologies, Uzbekistan

DOI: https://doi.org/10.37899/journallamultiapp.v1i5.275

Keywords: Telecommunication, Noise, Performance

Abstract

This article discusses noise in telecommunications: different types and methods of dealing with noise. Noise is arguably a very hated problem because it can interfere with the quality of signal reception and also the reproduction of the signal that will be transmitted. Not only that, but noise can also limit the range of the system to a certain emission power and can affect the sensitivity and sensitivity of the reception signal. Even in some cases, noise can also result in a reduction in the bandwidth of a system. Of course, we've all felt how annoying the noise effect is. For example, when listening to the radio, a hissing sound appears on the loudspeaker due to noise. To overcome noise, it is divided into passive noise control and active noise control. Passive noise control is an effort to overcome noise using components that do not require power. Generally passive noise control uses soundproof materials that act as insulation against noise. The method most commonly used to overcome noise is through increasing the gain. The noise is generally in a specific sound area. Hiss is on high frequencies, while noise and hum are on low frequencies. This is the principle underlying the noise reduction method.

References

Aekins, R. A. (2000). U.S. Patent No. 6,057,743. Washington, DC: U.S. Patent and Trademark Office.

Beritelli, F., Casale, S., Ruggeri, G., & Serrano, S. (2002). Performance evaluation and comparison of G. 729/AMR/fuzzy voice activity detectors. IEEE Signal Processing Letters, 9(3), 85-88.

Armada, A. G. (2001). Understanding the effects of phase noise in orthogonal frequency division multiplexing (OFDM). IEEE transactions on broadcasting, 47(2), 153-159.

Ho, C., Kantak, A., Slobin, S., & Morabito, D. (2007). Link analysis of a telecommunication system on earth, in geostationary orbit, and at the Moon: Atmospheric attenuation and noise temperature effects. The Interplanetary Network Progress Report, 42, 168.

Göbel, T., Stanze, D., Globisch, B., Dietz, R. J., Roehle, H., & Schell, M. (2013). Telecom technology based continuous wave terahertz photomixing system with 105 decibel signal-to-noise ratio and 3.5 terahertz bandwidth. Optics letters, 38(20), 4197-4199.

Samuelsson, J., Kleijn, W., & Grancharov, V. (2006). U.S. Patent Application No. 10/540,741.

Wu, S., & Bar-Ness, Y. (2002). A phase noise suppression algorithm for OFDM-based WLANs. IEEE Communications Letters, 6(12), 535-537.

Xu, F., Khalighi, M. A., & Bourennane, S. (2011, June). Impact of different noise sources on the performance of PIN-and APD-based FSO receivers. In Proceedings of the 11th International Conference on Telecommunications (pp. 211-218). IEEE.